Ahoj, (English below) Pokud vám po restartu VPS nestartuje LXD, je to pravděpodobně způsobeno změnou ve snapd. Ve verzi 2.60 dělali nějaké změny s AppArmorem a aspoň v našem prostředí pak LXD nestartuje. Chyba při instalaci např. vypadá takto: # snap install lxd error: cannot perform the following tasks: - Start snap "lxd" (25505) services (systemctl command [start snap.lxd.activate.service] failed with exit status 1: Job for snap.lxd.activate.service failed because the control process exited with error code. See "systemctl status snap.lxd.activate.service" and "journalctl -xeu snap.lxd.activate.service" for details. ) Jednoduchý workaround je v detailu VPS ve vpsAdminu zrušit feature "AppArmor control directories" (aby to nebylo zaškrtnuto). snapd ani LXD se potom nebudou snažit AppArmor použít a bude to fungovat. ENGLISH: If you're having an issue with LXD installed as snap not starting, it is most likely caused by a change in snapd. Version 2.60 contained some AppArmor-related changes which do not work correctly, at least not in our environment. For example, this is the error when trying to install lxd: # snap install lxd error: cannot perform the following tasks: - Start snap "lxd" (25505) services (systemctl command [start snap.lxd.activate.service] failed with exit status 1: Job for snap.lxd.activate.service failed because the control process exited with error code. See "systemctl status snap.lxd.activate.service" and "journalctl -xeu snap.lxd.activate.service" for details. ) A simple workaround is to disable feature "AppArmor control directories" in VPS details in vpsAdmin -- uncheck it. snapd and LXD will no longer try to use AppArmor and will work again. Jakub